favorite
favorite
hide
unhide
flag

Posted

print

60' Baker Windmill for sale - $1,900 (Windom)

60' Baker Windmill for sale 1 thumbnail60' Baker Windmill for sale 2 thumbnail60' Baker Windmill for sale 3 thumbnail60' Baker Windmill for sale 4 thumbnail60' Baker Windmill for sale 5 thumbnail60' Baker Windmill for sale 6 thumbnail60' Baker Windmill for sale 7 thumbnail60' Baker Windmill for sale 8 thumbnail
condition: good
make / manufacturer: Baker
We just took down grandpa's windmill. We had to cut the lower sections to get them out of the roof and soffit of pump house. The sections are approximately 20 long. The top two are 20'. the lowest was cut at about roof line (about 10'). So tower above ground is 60' tall. We unbolted at ground level, we plan to leave them there as they are part of cement now. The tower now laying on the ground is about 50' long, you would have to weld the cutoff 10' to get back to 60'. The tower now on its side is about 125" wide at its widest.
The fan and gear box were removed many years ago, to be replaced by TV antenna and/or windsock.
We think we have all the pieces. The blades are 13"wide at their widest. Blade length 29". When I spread the blades out the diameter of circle is about 99". I also noticed today that this one used 6 blade sections. I have 8, so the 2 that are bent are not important. I can say that because the gear box can only attach 6 sections. The first picture is showing 8 sections in a circle on the ground.
The gear box has Baker as the manufacturer. The tail might say Monitor (not sure), and does say made in Edgerton WI.
Located near Windom MN.
My cell is 608-three47-six08five

post id: 7732329379

posted:

updated:

best of [?]

loading
reading
writing
saving
searching